The Leverframe. 
This has built-in positive locking. It is made of castings plugged together and secured with a brass rod and nuts.  Levers pivoy on this rod, pass through the top plate at an angle and are held under pressure in the guide slots.  Gentle finger pressure against this spring lifts a lever out of the recess at each end of the guide slots and move it to the alternative setting where it is again locked.

Throw of lever - 4.75mm,  6.3mm,  8mm.

Fixing.
Use No. 2 screws through the feet, the length to suit your baseboard.  Be generous - this is a working unit!  Ensure a firm level seating.

1001 UNIVERSAL POINT LEVER (UPL)
Single non-locking lever with a variable throw of up to 4.75mm. (3/16th. inch)
Can be used singly or grouped together.
Fix with pins or small screws through slots at each end. Again be generous, ensure a firm seating.

1001T  As 1001 but supplied in a pack of 3 levers

1002  Angle cranks (brass cranks on a cast base)
Use these :- for sharp changes of direction, where space is limited, to link several features to one lever, to increase or decrease the throw. In normal use the wire in and wire out connect to the two inner or two outer holes. To increase the throw connect the wire in to the inner hole of one arm and the wire out to the outer hole of the other arm. To decrease the throw connect in reverse. If it is required to increase or decrease the throw on a straight run connect one wire to the inner hole and the other wire to the outer hole on the same arm.
Pack of 6 including fixing pins

1004  Steel wire  (3048mm - 10 foot coil)

1005    Omega wires  (pack of 6)
These take up any overthrow in the motion.
They attach to a leverframe with the loop standing vertically.
They attach to a UPL with the loop horizontal.

1006  Wire Snaps  (pack of 6)
Use to connect Omega wires to the control wire.
Insert wires into slots as shown in drawing and push top onto main body. Gently rivet over the the pins to prevent top working loose. Adhesive can be used if prefered. 
DO NOT SOLDER top on as this could damage the snap and / or prevent removal of the top if required. 

1007  Steel track pins  (9mm. - 3/8th. long).

1011  Large angle cranks - without bases. (pack of 10)
Length of arms - 18mm. Etched brass.

1012  Vertical angle cranks.   (pack of 6)
Use to turn motion from horizontal, through 90 degrees to a vertical motion

1013  Couplers (etched brass) - pack of 10.
Designed to connect a universal point lever to the 'pip' on a Peco point tie-bar.
If the lever is positioned next to a Peco point, solder or glue the small end to the  lever slidebar and drop the large end over the 'pip'.

1015   PTFE Flexi - Tube -  ( 3 mtr. Coil)
This microbore tube is approximately 1 mm in outside diameter and uses the same wire (1004) as the copper tube. An economical substitute for the copper tube. Can be used above or below the baseboard and in situations where more flexibility is required. 

£3.30

£8.25

£3.00

£2.45

£2.45

£2.45

£1.60

£10.45

£14.45

£16.45

£3.25

£3.00

£1.95

£3.00

£4.25

£6.00